Since the end of the 1980s in the rapid development of the industrial economy, the demand for infrastructure construction plants, equipment, and transportation facilities has increased dramatically. The demand for various metal tubes and bending machines is far from satisfactory. The shape requirements of metal tubes has also become more and more complicated, which has led to the development of system design and development. The tube bending technology was gradually developed and matured at that time. Today, our BLMA mechanical experts tube bending companies will tell you about how to keep the oil quality clean for pipe bending machine.

There is such a rule in the maintenance of the pipe bending device. The hydraulic system of the equipment must be regularly drained and refueled. Since the maintenance of oil clean quality is very important for the operation of the whole system. What specific requirements have been put forward for this?

Timing out the water and sediment in the hydraulic pipe bending machine tank is very important for removing impurities in the oil. At the same time, it is necessary to periodically empt the oil in the entire hydraulic system. This is for completely remove the system impurities and the oxidized hydraulic oil and other harmful substances. After completion, the clean hydraulic oil needs to be re-added to the system.

Since good hydraulic oil contain variety of additives, these additives prevent oil from deteriorating or block system parts, but after long-term use, no one can ensure its efficacy, and therefore need to be replaced regularly. In addition to draining and refueling, the oil filter replacement filter is one of the actions to keep the hydraulic pipe bender system clean.

So how do we extend the operating life of the pipe bender?

1. Do not place the bender in a place exposed to direct sunlight. Try to prevent the sun exposing which will cause the bender deform and crack.

2. Try to adhere to the neat and clean surface of the pipe bending machine. Do not stick adhesive paper and other items on the machine. Do not scribe on the table. If there is dust on the exhaust pipe bender dies, please use a wet towel with soapy water to scrub. Do not use Alcohol and other corrosive chemicals scrub the pipe bender.

3. In the pipe bending process, if it is difficult and dry to move the right and left right angle skateboards and the left and right feet, please clean the dust and debris in the track and use the 4B-B pencil core to slide on both sides of the sliding track and the sliding plate lower rail. Then it can recover as smooth as new.